GL100-WL (WIRELESS) AND GL100-N (NON-WIRELESS) STANDALONE SINGLE SENSOR SOLUTIONS
GL100-WL / N
Illuminance/UV sensor, Temp/Humidity sensor
GL100-WL / N
Carbon dioxide sensor, Temp/Humidity sensor
GL100-WL / N
Carbon dioxide sensor, Illuminance/UV sensor
GL100 COMBINED SENSOR DUAL PORT SOLUTIONS
The GL100 is a new compact handheld datalogger. Its body with universal input allows users to switch sensors and terminals for measuring various signals. The main body dimension is a slim 2.6″ wide x 3.93″ tall x 1.06″ thick (66mm x 100mm x 27mm) long, and weighs just over a quarter pound (130g).
- Powered by two AA batteries (not included) or USB bus power (includs MicroB-A USB cable)
- Onboard memory of 4.9MB
- External memory via Micro SD card slot
- Includes factory wireless LAN on the GL100-WL model.
The display is a back-lit monochrome type with a 128×64 dot resolution display with measured values and settings shown real time. Real-time data can be displayed while you record, and captured data can be displayed on PC using the application software included with the main unit (or downloadable from this site).
GL100-WL/GL100-N Compact Datalogger Key Values:
- Wireless Datalogging
- Up to 10 GL100 can be viewed on the software APS via USB on WLAN
- Swappable sensors and modules
- Measurement focused real-time APS software
- Apps available on iOS and AndroidOS platforms
FLEXIBLE INPUT MODULE ALLOWS WIDE RANGE OF MEASUREMENTS
New GS sensors and GS modules in volatile wireless and non-wireless environment have the ability to swap input modules using the GL100.
GL100 uses Wireless LAN (WLAN) IEEE802 standard, and area of use is limited by the Wireless Telegraphy Act in certain regions.
ELECTRICAL POWER USE MEASUREMENT
Compact datalogging solution for current and power use of lines up to 264V
Capable of up to 200A measurement
For single phase 3-wire, 2-wire, and 3-phase 3-wire current and power measurement
Selectable power factors
APPLICATION EXAMPLE IN
QUICK INSTALL POWER MONITORING
COLLECT RECORDED DATA WITH microSD* memory
DATA CAPTURING TIME (sample condition: measuring AC current and power using GS-DPA-AC, 1 minute sampling interval)
Built-in memory (approx. 4.9 MB) up to 178 days, microSD memory card over 2 years
Recording destination: internal memory (calculated by 4.9 MB)
Sampling: 30 sec. or 1 min.
Max. recording time = (Max. capacity / Record length) x Sampling interval
|Setting Items||Models||Record length (Byte)||
Max. Sampling 30 sec.
|Max. Sampling 1 min.|
|Temp. & Humidity||GS-TH||14||127||254|
|Acceleration & Temp.||GS-3AT||12||148||297|
|4ch, Voltage or Temp||GS-4VT||22||81||162|
|4ch, Temp. (Thermistor)||GS-4TSR||38||46||93|
|Illuminance & UV||GS-LXUV||16||111||223|
|Carbon dioxide (CO2)||GS-CO2||6||297||594|
|AC Current & Power||GS-DPA-AC||20||89||178|
|Temp./Humidity + CO2||GS-TH+GS-CO2||16||111||223|
|Temp./Humidity + Illuminance/UV||GS-TH+GS-LXUV||18||68||137|
|CO2 + Illuminance/UV||GS-CO2+GS-LXUV||26||99||198|